Torque converters 4R44E, 4R55E, 5R55E Torque converters Always use a pump gear alignment tool when setting up your 4R44E series. The A4LD was one of the first transmissions to use electronics to control the torque converter lockup mode. Eventually the 3 – 4 shift was also converted to. Rotate the T/C slowly as you apply light pressure to the center of the T/C until you feel it lock into the front pump, usually 2 seperate bumps felt, also if the trans has fluid after it locks into the pump fluid will come out the cooling line fittings when you rotate the converter. BE SURE that the converter is fully.
Torque Converter Identification; Removal & Installation; Our Staff. Transmission Identification Ford A4LD. You are here.
You'll need a transmisssion jack. The biigest concern is when installing the new transmission, make sure the torque converter is positioned so the front pump is still engaged before you start tightening any bolts. If the transmission will not contact the engine completely then the torque converter has come out of the front pump.
Lower the transmission and turn the torque converter slowly until you feel the spot where the pump engages and you can push the torque converter into the transmission. Realicn the transmission with the jack and start installing the mount bolts. When that is done then install the bolts that fasten the converter to the flywheel. Reconnect the wire harness and fill the trans.
Feb 11, 2015 . This involves removing the transmission as a unit, remove the lower access cover on the bell housing and unbolt flywheel from engine. You will have to rotate the engine manually with a socket and breaker bar. Drop the drive shaft from the rear axle and slide it out. Unhook coolant lines from transmission and linkage Support transmission with a transmission jack and make sure you have enough clearance to lower it, unbolt bell housing. Wiggle transmission slightly to break seal between bell housing and engine, move the jack and tranny back about an inch or two to disengage the pilot and pins, lower tranny onto jack. Bring it out into a good clean area and slide out the torque converter.
The seal can be pulled out with a seal puller, install new one with a seal driver and reinstall torque converter carefully making sure it engages correctly and does not sit proud of the bell housing. Reverse procedure. Alessandro Baricco Questa Storia Pdf. Make sure to use emergency brake and chocking, these tranny's are dangerously heavy so be sure to use a jack. Apr 10, 2011 . He overdrive off light flashing indicates that a problem with your transmission has been detected.